Installation
Flush Mount Drive Connection
Install your 3 Gang Box on or inside your wall
Install conduit between the Showstopper Base and network switch
Run Showstopper Cable and Cat5 Cable through conduit
Wire your cables into the back of the Drive Connection
Attach the green ground wire from the faceplate to the gang box
Attach the face plate to the gang box and begin using your Drive Connection!
Surface Mount Drive Connection
Remove the face plate from the back enclosure
Install the box on the wall. Be sure to use appropriate wall anchors
Install conduit between the Showstopper Base and network switch
Run Showstopper Cable and Cat5 Cable through conduit
Wire your cables into the back of the Drive Connection
Attach the green ground wire from the faceplate to the gang box
Attach the face plate to the gang box and begin using your Drive Connection!
Last updated
